ASSEMBLY VIDEO
Simple steps to assembling your new frame

INSTALLATION VIDEO
How to put your frame on your mirror

How To: A Step-by-Step Guide

ASSEMBLY STEPS (For unassembled frames only)

1. Lay frame pieces face down on a padded, flat surface.
2. Apply moderate amount of glue to end of one piece of frame.
3. Align adjoining frame piece to glued end.
4. Press corner connectors into slots until flush with back of frame. (Tap lightly with hammer if necessary)
5. Repeat steps 1-4 on all four corners.
6. Flip frame over and adjust if necessary.
7. Wipe off any excess glue with damp rag.
8. Allow at least 1 hour dry time for best results.

INSTALLATION STEPS

1. Remove tape backing from cardboard alignment corners only.
2. Hold frame up to desired position on mirror. (May take two people)
3. Apply alignment corners to mirror inside both upper corners of frame. (Place third support corner under upper middle of frame if provided)
4. Remove and adjust alignment corners if necessary until frame is in desired position. (Peel off corners slowly. Using a hair dryer will help make removal of corners much easier)
5. Carefully remove frame from mirror.
6. Remove tape backing from back of frame. (Do not allow anything to touch tape once backing is removed, as it is permanent)
7. Carefully lift frame and rest on alignment corners without allowing tape to touch mirror!
8. Starting at the top, slowly press frame against mirror, and then firmly press along entire length of frame.
9. Remove the alignment corners from mirror and you're done!
10. Show your friends and family what an amazing transformation your room has undergone!

A huge THANK YOU from your friends at Mirror Makeover!